JetCat P60-SE Special Edition Turbine complete with starter includes:

The new design of the P60-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability. The engine follows throttle commands almost without delay.

The P-60 is capable of kerostart with external kero plug “not included”.

Note: Battery not included.

Includes:

Jet-tronic ECU (fuel control electronics)

GSU (Display and Programmer)

LED I/O board

Miniature fuel pump

Electronic starting gas valve

Electronic Fuel valve

Fuel tubing, tubing connector set, filters, and cable set

Starting gas tank

Turbine mounting clamp, RamTec compatible

Detailed instruction manual

Note: Battery not included.

Specs:

 Thrust: 13 LB @ 165,000 RPM

Weight: 1.87 LB, incl. starter

Diameter: 3.25 inches

RPM Range: 50,000 – 165,000

Exhaust gas temp.: 580°C -690°C

Fuel consumption: 8 oz per/min at full power

Fuel: Jet A1, 1-K kerosene

Lubrication: approximately 5% synthetic turbine oil in the fuel

Maintenance interval: 25 hours